KILL

NAME
SYNOPSIS
DESCRIPTION
RETURN VALUE
ERRORS
NOTES
LINUX HISTORY
CONFORMING TO
SEE ALSO

NAME

kill − send signal to a process

SYNOPSIS

#include <sys/types.h>
#include <signal.h>

int kill(pid_t pid, int sig);

DESCRIPTION

The kill system call can be used to send any signal to any process group or process.

If pid is positive, then signal sig is sent to pid.

If pid equals 0, then sig is sent to every process in the process group of the current process.

If pid equals −1, then sig is sent to every process except for process 1 (init), but see below.

If pid is less than −1, then sig is sent to every process in the process group −pid.

If sig is 0, then no signal is sent, but error checking is still performed.

RETURN VALUE

On success, zero is returned. On error, −1 is returned, and errno is set appropriately.

ERRORS

EINVAL

An invalid signal was specified.

ESRCH

The pid or process group does not exist. Note that an existing process might be a zombie, a process which already committed termination, but has not yet been wait()ed for.

EPERM

The process does not have permission to send the signal to any of the receiving processes. For a process to have permission to send a signal to process pid it must either have root privileges, or the real or effective user ID of the sending process must equal the real or saved set-user-ID of the receiving process. In the case of SIGCONT it suffices when the sending and receiving processes belong to the same session.

NOTES

It is impossible to send a signal to task number one, the init process, for which it has not installed a signal handler. This is done to assure the system is not brought down accidentally.

POSIX 1003.1-2001 requires that kill(-1,sig) send sig to all processes that the current process may send signals to, except possibly for some implementation-defined system processes. Linux allows a process to signal itself, but on Linux the call kill(-1,sig) does not signal the current process.

LINUX HISTORY

Across different kernel versions, Linux has enforced different rules for the permissions required for an unprivileged process to send a signal to another process. In kernels 1.0 to 1.2.2, a signal could be sent if the effective user ID of the sender matched that of the receiver, or the real user ID of the sender matched that of the receiver. From kernel 1.2.3 until 1.3.77, a signal could be sent if the effective user ID of the sender matched either the real or effective user ID of the receiver. The current rules, which conform to POSIX 1003.1-2001, were adopted in kernel 1.3.78.

CONFORMING TO

SVr4, SVID, POSIX.1, X/OPEN, BSD 4.3, POSIX 1003.1-2001

SEE ALSO

_exit(2), killpg(2), signal(2), tkill(2), exit(3), signal(7)






....................................................................................................................................
About ~ Privacy Statement ~ Terms of Use ~ ~ All Linux-Documentation.com

Additional Reading